Specifications

NMM Agent Configuration View
Configuration Views Bay Networks BayStack Hubs
3-6 Management Module Guide
Current
Displays the current setting for the attachment point. The slot position of the
board, the setting of the backplane divider switch(es), and the mode setting
affect which backplane networks are valid values. Also, some boards may put
limitations on which backplane network(s) or local channel(s) may be used.
Default
Displays the default setting for the attachment point. An attachment point
may be attached to a local channel, not attached to any backplane network, or
attached to a media specific backplane network. (The valid choices depend on
each specific attachment point.) NOTE: This value will always be valid and
may change when the backplane divider switch setting is changed.
Changes
Displays the total number of attachment changes for the attachment point
that have been detected since cold/warm start of the agent.
Last Change
Displays the time since the last reset at which the most recent attachment
change for the attachment point was detected. If none have been detected
since restart of the agent, then the value is zero.
NMM Agent Configuration View
This view displays and provides detailed information on the configuration of
the agent, including the initial boot information. To access this view:
1. Within the Logical Device view, highlight the NMM icon.
2. From the View Menu, select Icon Subviews > NMM Agent
Configuration.
This view provides the following information:
RAM Version
Displays the version of the agent for the RAM of the module.
Initial Boot Info Source
Displays the source for initial protocol configuration information at next boot.
For IP, a setting of net using bootp means that BOOTP will be used to get
the agent’s IP address(es), load server address, and configuration file name.
For IPX, a setting of net using bootp means SAP will be used to get the
agent’s Novell network number(s), and the configuration filename will be
loaded from local storage. The load server address is not configurable and is