Technical data

Using the BayStack 350 Series 10/100 Autosense Switch
2-10
893-00992-D
Rack Mounting
You can install the BayStack 350 switch in most standard equipment racks. The
Model 350F and Model 350T require a single-unit (1u) rack space for installation.
The Model 350F-HD requires a 1.5-unit (1.5u) rack space for installation.
In most cases, you can install the switch in the rack with the mounting brackets
attached, as shown in Figure 2-5
. However, because of variances in rack hardware
(cagenuts), the switch may not fit between the rails. In this case, you can install the
switch by attaching the mounting brackets as shown in Figure 2-6
.
To install the BayStack 350 switch in an equipment rack, follow these steps:
1.
If rubber footpads are attached to the bottom of the switch, remove them.
2.
Depending on the width of your rack, use the standard or alternative
method of attaching the mounting brackets (Figure 2-5
or Figure 2-6).
3.
Using a Phillips or crosshead screwdriver, attach a mounting bracket to
each side of the switch using the supplied screws (Figure 2-5
or
Figure 2-6
).
Caution:
When mounting this device in a rack, do not stack units directly on
top of one another in the rack. Each unit must be secured to the rack with
appropriate mounting brackets. Mounting brackets are not designed to support
multiple units.
Note:
If you use the alternative method of attaching the mounting brackets to
the switch, the switch front panel will extend 2.54 centimeters (1 inch) from
the rack.