Technical data

Using the BayStack 350 Series 10/100 Autosense Switch
1-36
893-00992-D
The Inter-Switch Trunk Configuration screen for switch SW3 is configured as
follows:
• Trunk field (read only) --- indicates the trunk (I1 for this switch) that
corresponds to the switch ports specified in the Trunk Members fields.
• Trunk Members fields --- indicates the ports that can be configured, in each
row, to create the corresponding trunk:
– Ports 1 and 2 are assigned as trunk members of trunk I1.
• STP field --- indicates the spanning tree participation setting for each of the
trunks:
– Trunk I1 --- indicates that trunks I1 is enabled for spanning tree
participation.
• Trunk Mode field --- indicates the Trunk Mode for each of the trunks:
– Trunk I1 --- The Trunk Mode field for trunk I1 is set to Enhanced.
When in this mode, the switch evenly distributes source MAC
addresses to the trunk members, balancing traffic throughout each
trunk (see Note on page 1-31
).
• Trunk Status field --- indicates the Trunk Status for each of the trunks. When
set to Enabled, the configuration settings for that specific trunk are activated.
Trunk Configuration Screen for Switch SW4
As shown in Figure 1-16, switch SW4 is set up with one inter-switch trunk
configuration (I4). This trunk connects directly to switch SW1.
As in the previous screen examples, to set up an inter-switch trunk configuration
choose Inter-Switch Trunk Configuration from the MultiLink Trunk
Configuration Menu screen.
Figure 1-25
shows the Inter-Switch Trunk Configuration screen for switch SW4.