Technical data

Using the Console Interface
893-00992-D
3-65
Logout
The Logout command (accessed from the main menu) allows a user working at a
password-protected console terminal or in an active TELNET session to terminate
the session.
The Logout command works as follows:
• If the user is accessing the BayStack 350 switch through a TELNET session,
the Logout command terminates the TELNET session.
• If the user is accessing the BayStack 350 switch through a password-protected
console terminal (connected to the console/service port on the switch), the
Logout command displays the console-terminal password prompt
(Figure 3-33
). The user must enter the correct password to access the CI.
Figure 3-33. Password prompt screen
You can specify whether a password is required for the TELNET session or the
console terminal using the Console/Service Port Configuration screen (see
“
Console/Service Port Configuration” on page 3-45).
If the console terminal is not password protected, the system ignores the Logout
command.
BayStack Model 350T HW:RevC FW:V1.00 SW:V1.00
Password: [ *************** ]
Enter Password: