Technical data

Using the BayStack 350 Series 10/100 Autosense Switch
3-64
893-00992-D
Reset to Default Settings
The Reset to Default Settings command (accessed from the main menu) allows
you to reset the BayStack 350 switch and replace all configured switch parameters
with the factory default settings. For a list of the factory default settings, see
Appendix D, “Default Settings.”
The Reset to Default Settings command takes approximately five seconds to
complete. During this time, the switch initiates a self-test that comprises various
diagnostic routines and subtests. The LEDs display various patterns to indicate
that the subtests are in progress.
The results of the self-test are displayed briefly in the Self-Test screen
(Figure 3-32
), which is followed by the CI screens.
Figure 3-32. Self-Test screen after resetting the switch to factory default
settings
Caution:
If you choose this command, all of your configured settings will be
replaced with factory default settings when you press [Enter].
Note:
The Self-Test screen remains displayed only if the self-test detects a
fatal error.
BayStack Model 350T Self-Test
ASIC addressing test ... Pass
ASIC buffer RAM test ... Pass
Physical layer test ... Pass
Port internal loopback test ... Pass
Self-test complete.