Technical data

Using the BayStack 350 Series 10/100 Autosense Switch
3-58
893-00992-D
Software Download
The Software Download screen (Figure 3-27) allows you to revise the BayStack
350 switch software image that is located in nonvolatile flash memory. To
download the BayStack 350 switch software image, a properly configured Trivial
File Transfer Protocol (TFTP) server must be present in your network, and the
switch must have an IP address. (See “IP Configuration” on page 3-9
to learn how
to configure the switch’s IP address.)
Choose Software Download from the main menu to open the Software Download
screen.
You can monitor the software download process by observing the BayStack 350
switch LEDs (see “
LED Indications During the Download Process” on
page 3-59
).
Figure 3-27. Software Download screen
Caution:
Do not interrupt power to the device during the software download
process. If the power is interrupted, the firmware image can become corrupted.
Software Download
Image Filename: [ b350_100.img ]
TFTP Server IP Address: [ 192.0.1.12 ]
Start TFTP Load of New Image: [ Yes ]
The Software Download process has started. Do NOT power down the
switch before the process has completed (approximately 10 minutes).
Enter text, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.