Technical data

Using the BayStack 350 Series 10/100 Autosense Switch
3-30
893-00992-D
Server Trunk Configuration
The Server Trunk Configuration screen allows you to configure two to eight
switch ports together as members of a server trunk. Up to four server trunks can
be created for each BayStack 350 switch. Figure 3-14
shows an example of the
Server Trunk Configuration screen. In this screen example, one server trunk is
shown configured with four trunk members.
When a configured trunk is enabled, the trunk members (the specified switch
ports) take on default settings necessary for correct operation of the MultiLink
Trunking feature. These default settings can affect the correct operation of your
configured network. For more information, see “MultiLink Trunks” on page 1-22.
Choose Server Trunk Configuration from the MultiLink Trunk Configuration
Menu screen to open the Trunk Configuration screen.
Figure 3-14. Server Trunk Configuration screen
Note:
If you disable a trunk, you may need to reconfigure the specific trunk
members switch ports to return to the previous switch configuration.
Server Trunk Configuration
Trunk Trunk Members Trunk Status
----- ---------------------------- ------------
S1 [ 6 ][ 7 ][ 9 ][ 17 ] [ Enabled ]
S2 [ ][ ][ ][ ] [ Disabled ]
S3 [ ][ ] [ Disabled ]
S4 [ ][ ] [ Disabled ]
Valid server trunk configurations are:
1 or 2 trunks of up to 4 links each
Up to 4 trunks of 2 links each
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.