Technical data

Using the BayStack 350 Series 10/100 Autosense Switch
3-18
893-00992-D
Table 3-5 describes the Switch Configuration Menu screen commands.
Table 3-5. Switch Configuration Menu screen commands
Command Description
MAC Address Table
Displays the MAC Address Table screen (see “
MAC Address Table”
on page 3-19
). This screen allows you to view the MAC addresses
that the switch has learned.
VLAN Configuration...
Displays the VLAN Configuration screen (see “VLAN Configuration”
on page 3-21
). This screen allows you to set up VLAN workgroups.
Port Configuration...
Displays the Port Configuration screen (see “
Port Configuration” on
page 3-23
). This screen allows you to configure a specific switch port
or all switch ports.
MultiLink Trunk Configuration...
Displays the MultiLink Trunk Configuration Menu (see “MultiLink Trunk
Configuration” on page 3-26). This menu provides the following
commands: Inter-Switch Trunk Configuration, Server Trunk
Configuration, Trunk Utilization, and Return to Switch Configuration
Menu screen. This menu allows you to create trunks, to modify
configured trunks, and to monitor the bandwidth utilization of
configured trunks.
Port Mirroring Configuration...
Displays the Port Mirroring Configuration screen (see “Port Mirroring
Configuration“ on page 3-35). This screen allows you to designate a
single switch port as a traffic monitor for up to two specified ports.
Rate Limiting Configuration...
Displays the Rate Limiting Configuration screen (see “Inter-Switch
Trunk Configuration” on page 3-28). This screen allows you to limit the
forwarding rate of broadcast and multicast packets.
Display Port Statistics
Displays the Port Statistics screen (see “Port Statistics” on
page 3-41
). This screen allows you to view detailed information about
any switch port.
Clear All Port Statistics
The Clear All Port Statistics command allows you to clear all port
statistics for all switch ports. This command is followed by a screen
prompt which precedes the action. Enter Yes to clear all port statistics;
enter No to abort the command.
Return to Main Menu
Exits the Switch Configuration Menu screen and displays the main
menu.