Technical data

Using the BayStack 350 Series 10/100 Autosense Switch
3-14
893-00992-D
Table 3-3 describes the SNMP Configuration screen fields.
Table 3-3. SNMP Configuration screen fields
Field Description
Read-Only
Community String
The community string used for in-band read-only SNMP operations.
Default Value public
Range Any ASCII string of up to 32 printable characters
Read-Write
Community String
The community string used for in-band read-write SNMP operations.
Default Value private
Range Any ASCII string of up to 32 printable characters
Trap #1 IP Address
1
1
The Trap IP Address and Community String fields can be set using a MIB table (in a Bay Networks proprietary MIB). The
status of the row in the MIB table can be set to Ignore. If the row status is set to Ignore, the fields appear to be set when
viewed from the console terminal; however, no traps will be sent to that address until the row status is set to Valid.
Number one of four trap IP addresses. Successive trap IP address fields
are numbered 2, 3, and 4. Each trap address has an associated community
string (see Community String).
Default Value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal
point
Community String
The community string associated with one of the four trap IP addresses
(see Trap #1 IP Address).
Default Value Zero-length string
Range Any ASCII string of up to 32 printable characters
Authentication Trap
Determines whether a trap will be sent when there is an SNMP
authentication failure.
Default Value Enabled
Range Enabled, Disabled