Instruction manual

Installing and Stacking BayStack Hubs
2-4 893-839-C
Installing a Hub on a Wall
In a wall installation, Bay Networks recommends that the 100-series hub be
mounted on half-inch plywood attached to the wall where you intend to install
the hub.
You will need a #2 Phillips screwdriver for attaching mounting brackets.
To install a 100-series hub on a wall, follow these steps:
1. Attach the mounting brackets.
You can attach the mounting brackets in different positions on the hub.
The bracket configuration shown in this example centers the mounting
brackets on the hub (see F
igure 2-3). An alternate configuration would be
to install the left mounting bracket forward and the right mounting bracket
back, so that less space is required between mounted hubs.
a. Insert the #6 pan-head screws provided through each bracket and into
the mounting holes on the hub (see F
igure 2-3 step 1).
b. Tighten the screws to secure each bracket.
Figure 2-3. Attaching mounting brackets for wall mounting
2. Prepare the wall and attached plywood for installing the mounting
screws.
a. Using the mounting brackets on the hub as a guide, mark the mounting
screw locations on the plywood where you plan to install the hub.
b. Drill pilot holes in the plywood on your marks of the bracket holes.
7398
Step 1
Step 2
893-839-CBook Page 4 Thursday, December 12, 1996 4:18 PM