Instruction manual

Using the Console Interface
893-00992-A 3-21
The switch ports can be configured into logical workgroups by simply selecting
the port numbers vertically, under the VLAN names. You can allow any port to be
shared by users on a separate VLAN by selecting the same port horizontally under
each VLAN name you want to connect.
You can create VLANs based on a single BayStack 350T switch, or you can create
VLANs that span multiple switches, but each switch participating in the VLAN
configuration must be configured separately.
You can also assign multiple VLANS to a port that is connected to a server,
thereby allowing the server to be shared among multiple logical workgroups.
See “
Example VLAN Configuration” on page 3-22 to see VLAN configuration
screens set up for multiple BayStack 350T switches.
Note: To share VLANs between two switches, one connection per VLAN is
required. Do not assign multiple VLANS to switch-to-switch connections.
BOOK.MKR Page 21 Tuesday, March 4, 1997 7:24 PM