Instruction manual

Using the Console Interface
893-00992-A 3-7
Switch Configuration... Displays the Switch Configuration Menu (see “Switch Configuration” on
page
3-17). This menu provides additional configuration commands. The
commands include: MAC Address Table, VLAN Configuration, Port
Configuration, and Display Port Statistics.
Service Port Configuration... Displays the Service Port Configuration screen (see “
Service Port
Configuration” on page 3-32).
Spanning Tree Configuration... Displays the Spanning Tree Configuration Menu (see “
Spanning Tree
Configuration Menu” on page 3-34).
TELNET Configuration... Displays the TELNET Configuration screen (see “
TELNET
Configuration” on page 3-41).
Software Download... Displays the Software Download screen (see “
Software Download” on
page
3-44).
Display Event Log Displays the Event Log screen (see “
Display Event Log” on page 3-47).
Reset Resets the switch with the current configuration settings. When this
command is selected, the switch resets, runs a self-test, and displays the
Main Menu.
Reset to Default Settings Resets the switch with factory default configuration settings. When this
command is selected, the switch resets, runs a self-test, and displays the
Main Menu.
Caution: If you choose the Reset to Default Settings command, all of
your configured settings will be replaced with factory default settings
when you press [Enter].
Logout The Logout command allows a user at a password-protected console
terminal or an active TELNET session to disconnect the session (see
“
Logout” on page 3-51).
Table 3-1. CI Main Menu commands (continued)
Command Description
BOOK.MKR Page 7 Tuesday, March 4, 1997 7:24 PM