Instruction manual

Using the Console Interface
893-00992-A 3-51
Logout
The Logout command allows a user at a password-protected console terminal or
an active TELNET session to disconnect the session.
The Logout command performs the following functions:
• When accessing the BayStack 350T switch through a TELNET session,
selecting the Logout command disconnects the session.
• When accessing the BayStack 350T switch through a password-protected
console (a terminal connected to the service port of the switch), selecting the
Logout command returns you to the console terminal’s password prompt (see
Figure
3-27). The correct password must be entered to access the CI.
Figure 3-27. Password prompt screen
You can specify whether or not a password is required for the TELNET session or
for the console terminal using the Service Port Configuration screen (see “
Service
Port Configuration” on page 3-32).
The Logout command performs no function if the console terminal is not
password protected.
BayStack Model 350T HW:RevC FW:V1.00 SW:V1.00
Password: [ *************** ]
Enter Password:
BOOK.MKR Page 51 Tuesday, March 4, 1997 7:24 PM