Instruction manual

Using the BayStack Model 350T 10/100 Autosense Switch
3-50 893-00992-A
Reset to Default Settings
The Reset to Default Settings command allows you to reset the switch and replace
all configured switch parameters with factory default settings.
For a list of factory default settings, refer to Appendix
C, “Switch Default
Settings.”
The Reset to Default command takes approximately five seconds to complete.
During this period, the switch initiates a self-test that comprises various
diagnostic routines and subtests. The results of the self-test are displayed briefly
in the BayStack 350T Self-Test screen (see Figure
3-26), and is followed
immediately by the CI screens.
Figure 3-26. Example of a Reset to Default command self-test result
screen
The switch LEDs also display various patterns that indicate subtests are in
progress.
Caution: If you choose this command, all of your configured settings will be
replaced with factory default settings when you press [Enter].
Note: The BayStack 350T Self-Test screen remains displayed only if the
self-test detects a fatal error.
BayStack Model 350T Self-Test
ASIC addressing test ... Pass
ASIC buffer RAM test ... Pass
Physical layer test ... Pass
Port internal loopback test ... Pass
Self-test complete.
BOOK.MKR Page 50 Tuesday, March 4, 1997 7:24 PM