Instruction manual

Using the BayStack Model 350T 10/100 Autosense Switch
3-44 893-00992-A
Software Download
The Software Download screen (see Figure 3-21) allows you to revise your
BayStack 350T switch software image that is located in nonvolatile flash memory.
Note that to download the BayStack 350T software image, a properly configured
Trivial File Transfer Protocol (TFTP) server must be present in your network, and
your switch must be configured with an IP address (see “IP Configuration” on
page
3-8 to configure the switch IP address).
You can monitor the progress of the software download process by observing the
BayStack 350T LED indicators (see “
LED Indications During the Download
Process” on page 3-45).
Figure 3-21. Software Download screen
Caution: Do not interrupt power to the device during the software download
process. If the power is interrupted, the firmware image can become corrupted.
Software Download
Image Filename: [ b350_100.img ]
TFTP Server IP Address: [ 192.0.1.12 ]
Start TFTP Load of New Image: [ Yes ]
The Software Download process has started. Do NOT power down the
switch before the process has completed (approximately 10 minutes).
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
BOOK.MKR Page 44 Tuesday, March 4, 1997 7:24 PM