User guide

301945-A
4-1
Chapter 4
Putting Data on EDA Servers
This chapter tells you how to put data on the EDA servers to support your PCNs.
Procedures explained in this chapter:
To provide device files for PALs:
on page 4-4
To provide device files for EPROMs and flash PROMs:
on page 4-5
To make a revision change to SAP for a mechanical component:
on page 4-6
To rev SAP for AutoCAD, CADKEY, Computervision or other MCAD files:
on page 4-7
To send layout files:
on page 4-8
To provide updated schematic information:
on page 4-9
To supply documentation for a PCN:
on page 4-10
Introduction
The PCN/BOM process exists to make certifiable, traceable, and “releasable” files
available for others who need them. When you run
bn_bomprocess
and
bom_upload
, you make it possible for EDA to record the appropriate changes in
the SAP database and to move the project files into a controlled archive area such
as
/bay
dir
/dra/rel
, or in
ftp
or web directories so that other people can access
them.
The “To-Be-Released” Area
The directories that you put these files into are (where
dir
is either
west
or
east
):
•
/bay
dir
/dra/2brel/programs/
PartNumber.nn
/
•
/bay
dir
/dra/2brel/mech/
PartNumber.nn
/
•
/bay
dir
/dra/2brel/docs/
PartNumber.nn
/