User guide

Using partmgr to Update or Get a New Part Number
PCN Process User Guide (301945-A)
Using and Getting Part Numbers: 3-7
The following list identifies parts to pull, the class codes, and how to name the
parts.
Later, when you upload the BOM, you will specify a parent for each of these parts
(see
Getting the PCN Number
on page 6-7). This is all part of what is known as
structuring a BOM
, which is discussed more fully in
Structuring a BOM
on page
5-4 and
BOM Structures
on page E-9.
Table 3-1. Summary of Initial Parts to Take Out for a New Project
Part Name
Class
Code
Doc
Only
Comments
The following are necessary for every PCB
PWB Assy
Project_Name
920 Top-level assembly number for the
board
Rev Reg
Project_Name
122 y Revision registry is a file that
maintains all revision information
Dwg, PWA Assy
Project_Name
SUB y
Mech Outline
Project_Name
MEC y
PWB Raw
Project_Name
480 Raw PCB
Schem PWB
Project_Name
SCH y
BD MOD HIST
Project_Name
MOD y Board modification history file
RWK INSTR
Project_Name
REW y Rework instructions
The following may not be necessary for every PCB
KIT S/N PROM
Project_Name
119 Serial number PROM kit
SPEC S/N PROM
Project_Name
SPC y S/N PROM specification to each
specific product
DIAG PROM
Project_Name
119 Diagnostic PROM (raw part)
Boot PROM
Project_Name
119 Boot PROM
Boot PROM Prgm
Project_Name
120 y Software for boot PROM
PA L
Project_Name
119 One or more programmable parts
PAL Pgrm
Project_Name
120 y Software for each part