User guide

Part Numbers
PCN Process User Guide (301945-A)
Parts and Part Numbers: E-3
The class code is continued today, but it is not embedded in the part number.
When you create a part using
partmgr
, you re prompted to provide one (see
Table
Class Codes for Off-the-Shelf and Custom-Made Parts
on page E-13).
• 900-193, where there was no embedded major rev.
• 119-00423-A, where an extra two digits were added to accommodate numbers
greater than 1,000 (and 900-12345, when there was no embedded major rev).
• 119-00223-A-1.2.4, where they added versioning for software.
• 119-00622-A-T, where they added
document codes
, as listed in Table E-1.
Documentation-only codes are still in use today, but they are 3-letter codes that
you choose when you create a part. They are entered into SAP as
material groups
,
and thus are attributes of the part, but no longer reflected in the part number itself.
See the Table
Documentation-Only Class Codes (Material Groups)
on page E-13
for today’s codes.
Table E-1. Synoptics Document Codes
DOCUMENT TYPE CODE CLASS CODE
SUB-ASSEMBLY B 104,600,775,900-920
SCHEMATIC (118, 920) C 118,920
FINISHED PRODUCT ASSEMBLY (960, 970, 975, 980) D 960,970,975,980
ENGINEERING DESIGN SPECIFICATION E 118,920,960
ENGINEERING TEST REPORT F 118,920,960
MANUFACTURING TEST SPECIFICATION G -
FUNCTIONAL DESCRIPTION H 118,920,960
CODE, EXECUTABLE/OBJECT J 119,120,121,122,104
CODE, SOURCE K 119,120,121,122,104
MECHANICAL INTERFACE M 480
INCOMING INSPECTION SPECIFICATION N -
PANELIZATION DRAWING P 480
HARDWARE DESCRIPTION LANGUAGE R -
SOFTWARE CONFIGURATION DOCUMENT S -
RELEASE TEST ENGINEERING REPORT T -
ARTWORK (610, 765) 5 -