Technical data

Using Technician Interface Software
3-18
303561-A Rev 00
•A < target address> is unreachable message: This message appears if the
local Bay Networks router cannot find the specified address in its routing
table.
OSI ping: 49000400000a12121200 is unreachable
•An NSAP address is too short message: This message appears if the NSAP
address is too short. The minimum allowed NSAP address length is 20
hexadecimal characters (10 bytes). A sample message follows:
OSI ping: NSAP address is too short
•An OSI service is not running message: This message appears if the OSI
service is not enabled on the router. A sample message follows:
OSI ping: OSI service is not running
•A resource error message: This message appears if the router cannot
allocate a buffer for the request because none is available. A sample message
follows:
OSI ping: resource error
•A system error message: This message appears if the Technician Interface
has failed. A sample message follows:
OSI ping: system error
•A <y.y.y.y.y.y.y.y.y.y.y.y.y.y.y.y.y.y.y.y> is a bad NSAP address
message: This message appears if the NSAP address is more than 20
hexadecimal characters or contains nonhexadecimal characters. A sample
message follows.
OSI ping: 4900040000a1121212000 is a bad NSAP address