Technical data

Using Technician Interface Software
3-4
303561-A Rev 00
Enter the following to execute the last command you entered, where
<repeat_count> is the optional number of times you want to execute the
command. (The default is 1 time.)
! [ <repeat_count> ]
Examples:
Repeating a Command Recently Entered
Use the history command to
• View a list of the Technician Interface commands most recently entered
during the current console or Telnet session.
• Recall and run a specific command from the history list.
The router retrieves the list from the command history table.
The history list contains up to 20 commands by default. You can increase the
number of commands in the history list to a maximum of 40 by setting new values
for the console (serial port) attribute wfSerialPortHistoryDepth, and the Telnet
attribute wfTelnetHistoryDepth.
Example:
From a Technician Interface session, enter
%: set wfSerialPortEntry.wfSerialPortHistoryDepth = 40
%: set wfTelnet.wfTelnetHistoryDepth = 40
%: commit
By running the history command, you can recall and run any one of the last 40
commands you entered at the Technician Interface prompt.
!
Executes the last command you entered
! 5
Executes the last command you entered five times