Technical data

Configuring the Console Port
303561-A Rev 00
2-19
Using Autoscript Files
You can configure the Technician Interface to use the autoscript files automgr.bat
and autouser.bat, so that the Technician Interface executes certain commands
every time you log in as either a Manager or User.
To configure the Technician Interface to use these autoscript files, you must
modify the following serial port parameters:
• Login Script Search Path
• Manager’s Login Script
• User’s Login Script
• Force User Logout
Use the Login Script Search Path parameter to specify the list of file system
volumes to be searched. You can set up separate autoscript files to run for the
Manager login and the User login by configuring the Manager Login Script and
User’s Login Script parameters. You can set the Force User Logout parameter
when the User autoscript is in effect. This parameter locks the user into the User
autoscript. When this parameter is enabled, any attempt to abort the script results
in the user being logged out.
The Technician Interface configuration file, ti.cfg, looks for the automgr.bat script
when the Manager logs in, or for the autouser.bat
script when the User logs in. If
the autoscript is not present, login proceeds normally without any error messages.
The ti.cfg file has a default search path of slots 1 to 14 and a volume A. This works
for any platform.