Technical data

Using Technician Interface Software

2-4

303561-A Rev 00

Example:

The following commands set the Parity parameter to Odd:

set wfSerialPortEntry.wfSerialPortParity.1 2

set wfSerialPortEntry.10.1 2

Using the commit Command

Enter the following command after issuing one or more set commands:

commit

The commit command causes the changes you made to the configuration to take

effect in active memory, but not in flash memory. You must use the

save

command subsequently to save changes to a configuration file (config) and flash

volume on the router.

The Technician Interface software service resets when you enter the

commit

command.

Using the save Command

After you set and commit changes to the current configuration running in active

memory on the router, use the

save command to store that configuration to a file

on a flash memory volume, as follows:

save config

<vol>

Note:

You can use s instead of set.

Note:

You can also use the save command to save the current contents of the

router’s event log, environment variable list, or alias list. See Chapters 6, 7, and

9 for more information about these applications of the

save

command.