Technical data

303561-A Rev 00
2-1
Chapter 2
Configuring the Console Port
To configure a router’s console port parameters using the Technician Interface,
you have to change the default parameter settings associated with the console port
on the back of the router. You can change the default parameter settings for the
console port associated with the following boards:
• System Resources Link Module (SRM-L) board found in the BLN, BLN-2,
and BCN routers
• System Input/Output (SYS I/O) board found in the FN
™
, LN, CN, and ALN
routers
• Primary processor board found in the AFN
®
, AN, and ASN routers
• Base module found in ARN routers
The autoscript feature allows you to automatically execute certain Technician
Interface commands when you log in as either a Manager or User.
Note:
You can use the console port to connect either a console or modem to
the router.