Technical data

Using Technician Interface Software
C-22
303561-A Rev 00
Task 7: Adding More Hosts or Entity Filters
If you have finished adding entity filters for this remote host, and you do not want
to add another remote host at this time, go to Task 8. Otherwise, to add more hosts
or entity filters to your Syslog configuration:
• To add another entity filter for the same remote host, return to “Adding an
Entity Filter for a Remote Host” on page C-19
.
• To add another remote host to receive Syslog messages from the router, return
to “Adding a Remote Host to the Syslog Host Table” on page C-17
.
Task 8: Saving Your Syslog Configuration on the Router
Save to a file on an NVFS volume the Syslog additions to your configuration, as
follows:
save config
<vol>
:
<filename>
Task 9: Logging Out of the Technician Interface
Enter at the Technician Interface command line interface the following command:
$: logout
For more information about how to close a Technician Interface session with a
Bay Networks router, see Chapter 1.