Technical data

Using Out-of-Band Access to Transfer Files
303561-A Rev 00
B-5
Command Parameters
When you enter an
xmodem
command at the Technician Interface command line
prompt, follow the entry with only one of the following parameters:
Command Options
After you enter the
xmodem
command parameter that is appropriate for the
operation you need to perform (
sb
/
rb
), enter:
•The
y
option flag for any send binary or send receive operation
•The
w
option flag for any send binary operation
•The
p
option flag for any
xmodem
command you use to set the UNIX
workstation in either send binary or receive binary mode
•The
e
option flag for any
xmodem
command you use to transfer files to the
router using the Windows Terminal program
The
xmodem
option flags relevant to the YMODEM single- or batch-file transfer
protocol have the meanings shown in Table B-1
.
Parameter Name Meaning or Action
sb
Send Binary Sends files as they exist on disk or in
flash memory, without conversion.
st
Send Text Sends ASCII text files.
rb
Receive Binary Places files on disk or in flash
memory, without conversion.
YMODEM deletes existing files of
the same name.
rt
Receive Text Receives ASCII text files.