Technical data

Introducing the Technician Interface

303561-A Rev 00

1-3

Running the Technician Interface

The Technician Interface software entity normally runs on one slot only, except as

noted otherwise in the following table:

If you reset the slot on which the Technician Interface is running, the Technician

Interface resets to another available slot on a multislot system, or to the same slot

on a single-slot system.

Logging In

When you access the Technician Interface via Telnet or console session, you

encounter up to three levels of router access security:

• User/Manager Login (Telnet and console access)

• Password Authentication (Telnet and console access)

• SecurID Authentication (Telnet access only)

User/Manager Login

To access the Technician Interface on a Bay Networks router, you must enter one

of the following commands at the login prompt that appears in your Telnet or

console display:

Router Model Slot

, ANH

™

, ARN

™

Slot 1 only

ASN

™

Slots 1 to 4, individually or simultaneously,

depending on the number of ASN routers

stacked and the setup of the back panel for each

router

BN (BLN

, BLN-2, BCN

)Slot 2

or CN

with SYSCON-II flash

system controller

Any slot (one slot only)