Technical data

System Administration
303561-A Rev 00
8-51
If you accepted the default port, the following message appears on your
console display:
The default port 755 will be used for SecurID services.
If you entered a different port number, the following message appears on
your console or Telnet display:
The port <port_number> will be used for SecurID services.
Is this information correct? (yes/no)
[yes]
3.
If you entered no, go to step 4; otherwise, securelogin replies:
Telnet login now requires SecurID.
followed by:
Reinitialize Client? (yes/no) [yes]
a.
If you entered no, go to step 3b; otherwise, securelogin replies:
Client reinitialized.
You have completed the procedure. The SecurID client software on the
router has been reinitialized. If you want to disable SecurID login for
Telnet users, follow the procedure in the next section, “Disabling SecurID
Authentication.”
a.
If you entered no, securelogin replies with:
Client not reinitialized.
You have completed the procedure, but the SecurID client software on the
router has not been reinitialized.
4.
You entered no, indicating that the information about SecurID setup was
incorrect.
securelogin replies:
Do you still wish telnet login to require SecurID? (yes/no) [yes]
If you entered yes, return to step 2; if you entered no, go to step 5.
5.
You entered no, indicating that you do not want Telnet users to encounter
the SecurID login procedure; securelogin replies:
Securelogin information remains unchanged
Are you sure you want to turn off secure ID? (yes/no)
[yes]
If you entered yes, securelogin replies:
SecurID no longer required on Telnet login!