Technical data

Using Technician Interface Software
8-50
303561-A Rev 00
Enabling and Disabling SecurID Authentication
This section describes how to enable or disable SecurID services from a
Technician Interface session.
To enable or disable SecurID services, you answer questions from the securelogin
configuration utility running on the router. Press Return after each entry. If you
press Return without entering a response to a question, securelogin repeats that
question.
Enabling SecurID Authentication
Once you log in to the Technician Interface and the $ prompt appears on the
console display, proceed as follows to enable SecurID authentication services on
the router:
1.
Enter the following at the Technician Interface prompt:
$: securelogin
2.
Respond to each question that appears on your console display.
Do you wish telnet login to require SecurID? (yes/no)
[yes]
What is the IP address of the router being secured? (a.b.c.d)
[
<IP_Address>
]
What is the IP address of the SecurID server? (a.b.c.d)
[
<IP_Address>
]
What is the TCP port number for SecurID services? (default=755)
[
<TCP_Port_Number>
]
You have designated <IP_Decimal_Address> (or
<IP_Hexadecimal_Address> ) as your SecurID server.
Note:
You enable/disable SecurID services only from a router console (an
ASCII terminal or terminal emulator connected directly to the router console
port). You cannot enable/disable SecurID services through a Technician
Interface session supported through a Telnet connection to the router.
Note:
The sequence shows responses as bold text within brackets.