Technical data

System Administration
303561-A Rev 00
8-27
Resetting After Crossnet Shutdown Notification (BayStream Only)
On BayStream platforms only, you can use the
-shutdown
option of the
reset
command to reset one or more slots, following a “graceful crossnet shutdown” on
the same slots. With this option, the system notifies the remote end of any
associated Frame Relay Switch PVCs to expect a loss of connectivity. (The
BayStream software sends to the remote end of each PVC an update message
packet with the A-bit set to“inactive.”)
To initiate a graceful shutdown followed by a system or slot reset, enter the
appropriate command at the Technician Interface prompt:
The console displays the following message during shutdown:
Shutdown in progress.
If shutdown succeeds, the console displays the message
Shutdown is complete.
Upon issuing this message, the system performs the reset operation.
If shutdown fails, the console displays the message
Continue shutdown? (Y/N)
Note:
If you reset the slot in which the Technician Interface is running, the
Technician Interface resets with the next available slot on a multislot system,
or with the same slot on a single-slot system.
If you enter: The system resets:
reset -shutdown
All slots
reset -shutdown
[
<slot_no.>
]
One slot
reset -shutdown
[
<slot_no.>-<slot_no.>
]
A range of slots
reset -shutdown
[
<slot_no.>
,
<slot_no.>
,
. . .
,
]
A list of slots