Technical data

Using Technician Interface Software
8-26
303561-A Rev 00
Table 8-4. Router Reset Commands and Respones
You issued a reset command from a Technician Interface session (console or Telnet)
on one slot, and the target
<slot_no.>
you specified was:
(None)
The same slot on which the
session is running
A slot other than the slot
on which the session is
running
Command-
>
reset reset
<slot_no.>
reset
<slot_no.>
|
Router V
AN
ANH
ARN
(single-slot)
Warm-boot slot 1:
• No diagnostics
• Load new image on slot 1
• Initialize new image on
slot 1
• Retain log info
Warm-boot slot 1:
• No diagnostics
• Load new image on slot 1
• Initialize new image on
slot 1
• Retain log info
N/A
AFN
(single-slot)
Warm-boot slot 2:
• No diagnostics
• Load new image on slot 2
• Initialize new image on
slot 2
• Retain log info
Restart slot 2:
• No diagnostics
• No image reload on slot 2
• Reinitialize current image
on slot 2
• Retain log info
N/A
ALN
CN
FN
LN
(multislot)
Warm-boot all slots:
• No diagnostics
• Load new image
• Initialize new image
• Retain log info on all slots
Warm-boot the designated
slot:
• No diagnostics
• Load new image on local
slot
• Initialize new image on
local slot
• Retain log info on
designated slot
Cold-boot the designated
slot:
• Run diagnostics on the
designated slot
• Load new image on the
designated slot
• Initialize new image on
the designated slot
• Lose log info on the
designated slot
BLN
BLN-2
BCN
(multislot)
Warm-boot all slots:
• No diagnostics
• Load new image
• Initialize new image
• Retain log info on all slots
Warm-boot the designated
slot:
• No diagnostics
• Load new image on
designated slot
• Initialize new image on
designated slot
• Retain log info on
designated slot
Warm-boot the designated
slot:
• No diagnostics
• Load new image on the
designated slot
• Initialize new image on
the designated slot
• Retain log info on the
designated slot