Technical data

System Administration
303561-A Rev 00
8-3
Configuring the Boot Source
To use Directed Netboot, you must use the
bconfig
command to specify the
following:
• The IP address of the server where the router’s software image and
configuration file reside
• The full path name of the software image and configuration file
You must use the
bconfig
command once to specify the location of the software
image, and again to specify the location of the configuration file.
Use one of the following formats for the
bconfig
command:
bconfig
[
image
|
config
] [
local
|
network
[ <TFTP_host> <TFTP_pathname> ]]
bconfig -d
[
image
|
config
]
Table 8-1
describes command options for the
bconfig
command.