Technical data

Using Technician Interface Software
7-8
303561-A Rev 00
Examples:
Committing MIB Sets
The
commit
command causes all previously entered
set
commands to take effect.
When you enter
commit
, the system notifies all software services whose
configuration parameters have changed.
See the next section for instructions on copying all MIB values from operating
RAM to a configuration file for later retrieval.
Entering one of the following:
set wfSnmp.wfSnmpDisable.0 1
set 1.3.6.1.4.1.18.3.5.3.5.1.1.0 1
set wfSnmp.1.0 1
Changes the value of
wfSnmp.wfSnmpDisable.0
(1.3.6.1.4.1.18.3.5.3.5.1.1.0) to 1 to enable
SNMP
Entering:
set
wfIpInterfaceEntry.2.192.32.13.99.3
2
Changes the value of
wfIpInterfaceEntry.WfIpInterfaceEnable.192.3
2.13.99 to 2, which disables IP for the
interface whose IP address is 192.32.13.99
and whose circuit is 3
Entering one of the following:
set wfBrTp.2.0 1
set wfBrStp.2.0 1
Changes the values
wfBrTp.wfBrTpBaseEnable.0 and
wfBrStp.wfBrStpBaseEnable.0 to 1 to enable
the translating bridge and spanning tree
Entering one of the following:
set wfBrTp.2.0 2
set wfBrStp.2.0 2
Disables the translating bridge and spanning
tree