Technical data

Managing a DOS File System
303561-A Rev 00
5-11
s5000diag.exe
A copy of the diagnostics image resident on a System 5000
router. You cannot read or change this file.
config
The default configuration file.
The system refers to this binary file for configuration data when
booting. You can change the configuration by copying an
alternative configuration file to
config . You can also use the boot
command to specify a different configuration file.
This file must have the
config file name for the system to
configure automatically after booting. We recommend that you
copy
config to a new backup file name before overwriting it.
debug.al
An ASCII file containing aliases (commands that abbreviate
long or multiple commands) that you can use to debug common
network problems. (See “Debugging with Predefined Aliases”
in Chapter 9 to use the aliases in this file.)
frediag.exe
A copy of the diagnostics image resident on the diagnostics
PROM of a BLN, BLN-2, or BCN router. You cannot read or
change this file.
freboot.exe
A copy of the bootstrap image resident on the bootstrap PROM
of a BLN, BLN-2, or BCN router. You cannot read or change
this file.
install.bat
A script file that you use during the initial startup of all router
platforms except the ARN.
inst_arn.bat
A script file that you use during the initial startup of the ARN
only.
ti.cfg
A configuration file containing the MIB variables associated
with the default Technician Interface console operating
parameters. This file contains the minimal configuration
necessary to operate the router. This file is stored in binary
format.