User manual

Installing and Operating BayStack ARN Routers

1-6 114200 Rev. A

Rack-Mounting the ARN

For this procedure, you need

• Four #10 cagenut screws and washers (shipped with the ARN)

• Two ﬂange brackets and eight #6 ﬂathead screws (shipped with the ARN)

• A Phillips screwdriver

• An electronic enclosure rack

To rack-mount the ARN:

1. Attach a ﬂange bracket to both sides of the ARN.

On each side of the chassis:

a. Align the holes in the longer end of the ﬂange bracket with the

mounting holes near the front panel of the ARN (F

igure 1-2).

b. Insert a #6 ﬂathead screw through each hole and into the ARN.

c. Tighten the four screws with a Phillips screwdriver.

Note: If the rack does not have threaded rail holes, you must supply and attach

four cagenuts.