Technical data
116273-B Rev 00
A-1
Appendix A
Configuring the ARN/DC for
Netboot and Directed Netboot
The following commands configure the ARN/DC for Netboot and Directed
Netboot:
The
ifconfig
and
bconfig
commands configure the ARN/DC for netboot and
directed netboot.
• Use the i
fconfig
command to configure the router initial IP interface to the
network. You need this information to complete the procedure in “Continuing
with Netboot” on page 2-8.
• Use the
bconfig
command to specify the location and name of the ARN/DC
software image file and the configuration file. You need this information to
complete the procedure in “Continuing with Directed Netboot” on page 2-10.
To determine the appropriate
ifconfig
command and
bconfig
commands for the
ARN/DC at your site, contact your network administrator. (Your network
administrator has information on these commands in Configuring BayStack
Remote Access.)
Topic Page
Using the ifconfig Command A-2
Using the bconfig Command A-6
Verifying Your Configuration A-7