Technical data

Installing and Operating BayStack ARN/DC Routers
4-4
116273-A Rev. 00
Removing the Filler Panel
To remove the filler panel from an empty adapter module slot:
1.
Using a Phillips screwdriver, remove the screw that secures the filler
panel in either slot 1 or slot 2 (Figure 4-2)
.
Figure 4-2. Removing the Filler Panel from Slot 1
2.
Grasp the metal tab on the filler panel and pull forward to remove the
panel.
3.
Set the filler panel aside.
To operate the ARN/DC without an adapter module in this slot, you must
reinstall the filler panel.
4.
Skip the next section and go to “Installing an Adapter Module” on
page 4-6
.
1
2
ARN0077A
Metal tab on filler panel
Telco
Tx
Rx
RLSD
DTR
DSU/CSU