Technical data

Installing and Operating BayStack ARN/DC Routers
3-12
116273-B Rev 00
•To cold-boot the ARN/DC (diagnostic tests run), press the Reset button for
more than 5 seconds.
Removing a Flash Memory Card
To remove a memory card from the ARN/DC:
1.
Press the eject button next to the card receptacle on the back panel.
The card pops out slightly.
2.
Pull the memory card out of the card receptacle (Figure 3-4).
Figure 3-4. Removing a Flash Memory Card
When you remove a formatted memory card, the nonvolatile file system (NVFS)
automatically removes access to the card. When you insert and format a card or
insert an already formatted card, the NVFS automatically provides access.
Note:
If you reset the ARN/DC while it is running its diagnostic tests, the
LEDs remain in the state they were in when you pressed the Reset button. You
must cycle power on the ARN/DC to reset the LEDs.
Caution:
Do not remove the flash memory card while the router is operating.
Removing the memory card interferes with current networking operations.
ARN0087A
Console Modem
Redundant Power
+
_
1
2
I
0