Technical data

Starting the ARN/DC
116273-B Rev 00
2-13
When the ARN/DC boots, its LEDs flash in a particular order. To ensure that
the installation was successful, see “Ensuring a Successful Installation” on
page 3-8.
6.
Ensure that the ARN/DC is successfully connected to your network.
To verify that the ARN/DC is now connected to the network, contact your
network administrator. To troubleshoot any problems, your network
administrator can refer to Configuring BayStack Remote Access.
If you need additional assistance, contact your local Bay Networks Technical
Solutions Center.
Continuing with Local Boot (the Quick-Start Procedure)
You can use either the ARN/DC monitor or the Technician Interface to configure
the ARN/DC to local boot. However, you must use the Technician Interface to run
the Quick-Start script.
Note:
After connecting the ARN/DC to the network, you can replace the
management console connection with a modem connection to enable remote
dial-in access.
Note:
Continuing with the netboot option requires that you have already
logged in to either the ARN monitor or Technician Interface command line
software. For instructions, see “Logging in to the Command Line Software” on
page 2-7.
Note:
Before starting the local boot procedure, ask your network administrator
to assist you in completing the Quick-Start worksheets in “Filling Out the
Worksheets” on page B-4.