Technical data

Installing the ARN/DC
116273-B Rev 00
1-11
Connecting to the AUI Interface
The AUI interface provides broadband, baseband, fiber, and shielded twisted pair
(STP) support, depending on the transceiver and cables you use.
To connect an Ethernet transceiver (drop) cable to an AUI connector on an
Ethernet module:
1.
Connect the transceiver cable to the interface labeled AUI (Figure 1-5).
The cable must have a 15-position D-SUB receptacle.
Figure 1-5. Connecting an Ethernet Transceiver Cable
2.
Secure the transceiver cable using the slide lock on the AUI interface.
3.
Connect the other end of the cable to an Ethernet transceiver.
Caution:
Connecting the ARN AUI interface directly to the AUI interface on
an Ethernet station violates IEEE 802.3 standards. The AUI interface is
designed only for connection to a transceiver.
Caution:
Connecting the ARN/DC AUI interface directly to the AUI interface
on an Ethernet station violates the IEEE 802.3 standard. The AUI interface is
only for connection to a transceiver.
ARN0063A
COM3 COM4 COM5
COM
U
D
DD
B1
B2
RLSD
Run
Boot
Diag
Pwr
RPS
Fan
Base
Adapter1
Adapter2
Expansion
DCM
PCMCIA
BayStack Advanced Remote Node
RLSD3
RLSD4
RLSD5
1
2
Serial
Serial
ISDN BRI
withNT1
Tx
Rx
Cl
Tx
Rx
Cl
10BaseT
AUI
Ethernet 1
10BaseT
AUI
Ethernet 2
Expansion module AUI interface
Base module AUI interface
To
Ethernet
transceiver
Ethernet AUI drop cable