Technical data

Overview of the ATMSpeed/155 Modules and Media Dependent Adapters

893-01047-A 1-9

• The following ATM connectivity is currently supported by the switch

software:

— ATM connectivity between two Centillion 100 switches with or without

intermediate ATM switches

— ATM Forum UNI 3.0 and 3.1 compliance (release 2.0 or later)

— Connectivity to another manufacturer’s ATM switch or to carrier services

through PVC/PVP or Interim Inter-switch Signaling Protocol (IISP)

(release 2.0 or later)

— Connectivity to ATM adapters or ATM routers and other UNI devices

through UNI 3.x (release 2.0 or later)

Fault Tolerance

The following fault tolerance features are supported on the Centillion 100

modules:

• Ability to install, remove, and replace a module in an operational chassis

(hot-swapping)

• Software update and management access over the network or a serial

connection on the ATMSpeed/155 MCP and ATMSpeed/155 MDA MCP

modules

Network Management

You can manage and conﬁgure the ATMSpeed/155 module through access to the

MCP module with the following network management features:

• Simple Network Management Protocol (SNMP) agent with Centillion 100

management information base (MIB) extensions

• Bootstrap Protocol (BootP) and Trivial File Transport Protocol (TFTP)

support

• SpeedView

™

application for conﬁguration management and monitoring.

SpeedView for Windows runs over SNMP or serial port connection.

For additional information on SpeedView, refer to Using SpeedView 2.1 for

Windows.