Technical data

893-01047-A
xi
Figures
Figure 1-1. Hardware features of the ATMSpeed/155 module with two MMF or
SMF ports ................................................................................................1-3
Figure 1-2. Hardware features of the ATMSpeed/155 switch module with four
MMF ports and the 10BASE-T and serial MCP ports ..............................1-3
Figure 1-3. Hardware features of the ATMSpeed/155 module with two MDA slots for
two-port SMF, MMF, and UTP MDAs, one 10BASE-T Ethernet port
(RJ-45), and one serial port (Mini DIN 8) .................................................1-4
Figure 2-1. Removing the filler panel .........................................................................2-3
Figure 2-2. Inserter/extractor levers ready for installation ..........................................2-3
Figure 2-3. Slot module guides ..................................................................................2-4
Figure 2-4. Inserting the module until it engages the backplane ................................2-4
Figure 2-5. Seating the module ..................................................................................2-5
Figure 2-6. MDA slot cover screws .............................................................................2-6
Figure 2-7. Removing an MDA slot cover ...................................................................2-6
Figure 2-8. Installing the MDA ....................................................................................2-7
Figure 2-9. Aligning the MDA connector ....................................................................2-7
Figure 2-10. Seating MDA in the baseboard connector ...............................................2-8
Figure 2-11. Tightening screws ....................................................................................2-8
Figure 2-12. Attaching product label ............................................................................2-9
Figure 2-13. Preparing the MDA for removal ................................................................2-9
Figure 2-14. Removing the MDA from the switch module ..........................................2-10
Figure 2-15. Installing the new MDA ..........................................................................2-10
Figure 2-16. Aligning the MDA connector ..................................................................2-11
Figure 2-17. Seating the connector ............................................................................2-11
Figure 2-18. Tightening screws ..................................................................................2-12
Figure 2-19. Connecting a UTP cable to an ATM MDA ..............................................2-12
Figure 2-20. Removing the dust plug from the MDA SC connector ...........................2-13
Figure 2-21. Removing a dust cap from the MDA fiber cable connector ....................2-14
Figure 2-22. Inserting the cable connector into the MDA connector ..........................2-14