Operating instructions

ManualsBrandsBay Networks ManualsComputer equipment6300

ADDRESSING SAFETY SYSTEMS WITH INTELLIGENCE

Fire Detection - Addressable

6000/MCP FAST

Addressable Manual Call Point - Key

operated test facility, a loop short circuit isolator

is incorporated.

6000PLUS/UG4DP Ventilation Duct Smoke Sensor Assembly - Single

pipe air sampling unit for air speeds from 0.5 to 20m

per sec. supplied with 6000PLUS/BASE suitable for

use with 6000PLUS/OP FAST

interactive optical

smoke sensor.

6000/FIREBEAM FAST

Addressable Loop Powered Beam

Detector - Combined transmitter/receiver unit and

separate low level controller. With a beam range

of 5-100 metres.

6000/LED FAST

Addressable Loop Powered High Intensity

Flashing Beacon - The 6000/LED has 18 high

intensity LEDs, and due to the low current design,

is addressable and loop powered, utilising the

Protec Algo-Tec

6000 Protocol.

6000/FIU Flush Mounted Short Circuit Isolator Unit - To

isolate a short circuit fault on either the incoming

or outgoing loop cables. Suitable for a 30mm deep

electrical mounting box.

6000/LPZA FAST

Addressable Flush Mounted Loop

Powered Zone Alarm Interface Unit - With a

monitored detection circuit suitable for use

with Protec 3000 series detection devices. Line

continuity maintained. Monitored alarm output

circuit rated at 24Vdc 50mA max. Suitable for a

45mm deep electrical mounting box. A loop short

circuit isolator is included.

6000/ZAI FAST

Addressable Flush Mounted Zone Alarm

Interface Unit - With a monitored detection circuit

suitable for use with Protec 3000 series detection

devices. Line continuity maintained. Monitored

alarm output circuit rated at 24V dc 1A max.

Suitable for a 45mm deep electrical mounting box.

A loop short circuit isolator is included.

Multi-way Input/Output Interfaces - A range of 16 way input/

output interfaces are available with monitored

alarm outputs or clean changeover contacts. All

interfaces are FAST

addressable.

Table detailing the loop standby and alarm load for typical

Algo-tec™ 6000 devices.

Note: The following Loop Parameters should be observed

1) The total number of addressable devices should not exceed 191 per loop.

2) Add 20mA to total loop alarm load to allow for fire indicator LED’s on devices

3) The total loop alarm load should not exceed 600mA per loop.

* Auxiliary 24V dc supply required.

Guide to loop cable conductor sizing for the Protec 6300 system.

Loop Length (Metres)

Total

Loop

Load

Alarm

(mA)

100

150

200

250

300

350

400

450

500

550

600

100

150

200

250

300

350

400

450

500

550

600

1000

1050

1100

1150

1200

1250 1300

1350

1400 1450

1500

500 550 600650 700750 800850 900950 1000

Total

Loop

Load

Alarm

(mA)

n/a

n/an/an/a

The conductor size required is as follows

1.0mm² Conductor required.

1.5mm² Conductor required.

2.5mm² Conductor required.

Maximum loop resistance 16 ohms per conductor

6000/SSR FAST

Addressable Loop Powered High Output

Electronic Sounder - utilises a Piezo driver unit

to enable high sound output and very low current

consumption.

The conductor size required as follows

1.0mm

Conductor required

1.5mm

Conductor required

2.5mm

Conductor required

MAXIMUM LOOP RESISTANCE 16 OHMS PER CONDUCTOR

6000/MICCO FAST

Addressable Flush Mounted Loop Powered

Monitored Input, Clean Contact Output Interface

Unit - With a monitored input circuit suitable for

use with simple switch devices and the output is

a clean changeover contact 5amp rated at 240V

ac. A link can be cut to provide a 7-second delay

to the input. Suitable for a 45mm deep electrical

mounting box. A loop short circuit isolator is incorporated.

6000/SSR/LED FAST

Addressable Loop Powered High Output

Electronic Sounder with LED Beacon - a low

current loop powered addressable device. With

typical sound output of 100dB(A) at 1m, the tone

and volume options are selectable by the control

panel.

6000PLUS/TSR2 FAST

Addressable Loop Powered Talking

Sounder - The 6000PLUS/TSR2 voice enhanced

talking sounder is available with seven voice

messages plus ‘bell’ sound in addition to the three

fire alarm tones compatible with the Protec range

of electronic sounders.

6000PLUS/TSR2/LED FAST

Addressable Loop Powered Talking

Sounder with LED Beacon - the Protec Algo-

Tec™

6000PLUS/TSR2/LED is equipped with an

integrated voice enhanced sounder and high

intensity flashing beacon array.

Product Description

Number of

Addresses

Loop

Standby

Load mA

Loop Alarm

Load mA

6000/MCP Manual Call Point 1 0.5 3.4

6000/FIREBEAM Loop Beam 1 3.65 7

6000PLUS/HT Heat Sensor 1 0.2 0.2

6000PLUS/HT/S Heat Sensor c/w Sounder 1 0.4 5.4

6000PLUS/OPHT Optical Smoke and Heat Sensor 1 0.2 0.2

6000PLUS/OPHT/S

Optical Smoke and Heat Sensor c/w

Sounder

1 0.4 5.4

6000PLUS/OPHT/SL

Optical Smoke and Heat Sensor c/w

Sounder and Beacon

1 0.4 10.4

6000PLUS/OPHT/TSL

Optical Smoke and Heat Sensor c/w

Talking Sounder and Beacon

1 0.4 13.4

6000PLUS/OPHTCO Optical Smoke, Heat, and CO Sensor 1 0.45 0.45

6000PLUS/OPHTCO/S

Optical Smoke, Heat, and CO Sensor

c/w Sounder

1 0.45 5.45

6000/LED Loop Beacon 1 0.5 5.5

6000/SSR Loop Sounder 1 0.7 5.7

6000/SSR/LED Loop Sounder Beacon 1 0.7 10.7

6000/ZAI* Zone Alarm Interface 1 2 4

6000/MICCO Monitored Input CC Output 1 0.55 5