User`s guide

58 007-5782-001
6: Basic Troubleshooting and Chassis Service
Replacing System Fans
This section describes how to remove or install a system fan.
Removing a Fan
1. Remove the chassis cover.
2. Press the tabs on the sides of the fan to unlock and remove the fan and its housing. The fan's
power connections will automatically detach.
3. System power does not need to be shut down since the fans are hot-pluggable.
Installing a New Fan
1. Replace the failed fan with an identical 8-cm, 12-volt fan.
2. Position the new fan into the space vacated by the failed fan previously removed. A click can
be heard when the fan is fully installed in place and the power connections are made.
3. If the system power is on, the hot-plug feature will cause the fan to start immediately upon
being connected to its header on the serverboard.
Drive Bay Installation/Removal
This section describes drive bay installation and removal for HDD/SSD drives and for DVD-ROM
drives.
HDD Drive Installation
You do not need to access the inside of the chassis or remove power to replace or swap the drives.
Note: You must use standard 1" high drives in the system.
The drives are mounted in drive carriers to simplify their installation and removal from the
chassis. These carriers also help promote proper airflow for the drives. For this reason, even empty
carriers without hard drives installed must remain in the chassis.