User`s guide

16 007-5782-001
2: Server Installation
Check the CPUs (processors)
You may have one or two processors installed into the serverboard. Each processor needs its own
heatsink.
Check the System Memory
Your server system is shipped with system memory installed. Make sure all DIMMs are fully
seated in their slots. For details on adding system memory, refer to “Installing Memory” on
page 34.
Install Expansion PCI Cards
Refer to “PCI Expansion Slots” on page 50 for details on installing PCI expansion cards.
Check all Cable Connections and Airflow
Make sure all power and data cables are properly connected and not blocking the chassis airflow.
Check the Drive Bay Setup
Next, you should check to make sure the system disk drives and disk drive backplane have been
properly installed and all connections have been made.
Check the System Disk Drives
All drives are accessable from the front of the server. For servicing the DVD-ROM, you will need
to remove the top chassis cover. The hard drives can be installed and removed from the front of
the chassis without removing the top chassis cover. Depending upon your system configuration,
your system may have one or more drives installed. For detailed information about how to install
disk drives, see “Disk Drives (HDDs or SSDs)” on page 49.
If you have more than 4TB of storage, you must create multiple volumes to fully utilize your
RAID disks.