User manual

4-9Remote Annex 6300 Hardware Installation Guide
Chapter 4 Troubleshooting Procedures
Setup Mode Error States
Table 4-5 contains a description of the LEDs that are used to describe
errors that occur at different stages of the system start-up process. If
the Remote Annex 6300 fails while testing the hardware, (state T2),
the error condition is hardware failure TE2. A description of each error
condition follows
Table 4-5.
Table 4-5. Normal Mode Error LED States
Key:
● On continuously.
✕ Off.
■ Flashing irregularly.
◆ Flashing regularly (about 1Hz).
Activity TE2:
Hardware Failure
The ROM diagnostics detected a Remote Annex 6300 hardware
problem requiring service. Call Customer Support.
Activity TE7: Booted
Wrong Image
The Remote Annex 6300 loaded an inappropriate image. Press the
button for 3 seconds to reset the device. Following is a list of
ways to prevent this problem in the future:
❑ Be sure that you configure the Remote Annex 6300 with the
appropriate image.
❑ Be sure that the image you are booting has the right name.
Don’t rename the image file unless you are making a copy
for safe keeping.
❑ If you used an na, admin, or cli boot command, specify the
correct image and a valid filename.
Activity
STAT
Green
ATTN
Amber
TRAF
Green
TE2: Hardware Failure
◆ ◆ ✕
TE7: Booted Wrong Image
● ◆ ✕
Reset