User manual

Remote Annex 6300 Hardware Installation Guide
Appendix D Modem Upgrade Instructions
D-6
2 Secure the cover by installing the 17 screws back into the cover,
starting at the rear and working to the sides.
Do not over-tighten these screws (beyond 10 in-lbs.
of torque).
Power-up and Test
The following instructions describe the power-up and test sequence.
1 Reconnect all the cables, including:
❑ The Ethernet cable
❑ The PRI ISDN Interface cable
❑ The console terminal cable
❑ The power cord
2 Turn on the unit’s power.
3 Set the Remote Annex to Test mode by pressing and holding the
button (located on the front panel) for three seconds
(see
Figure D-4).
The Remote Annex runs its ROM-resident power-up diagnostics.
Figure D-4. Setting the Remote Annex 6300 to Test Mode
Reset
Reset
Button
Bay Networks
Remote Annex 6300
Xylogics, a Bay Networks Company
32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15
Modem Status
1413121110987654321
CD
Tx/Rx
13-16 9-12 5-8 1-4
29-32 25-28 21-24 17-20
Modem Config
Status
Test Sync Los
Red Yel Blu
Stat Traf
Setup
Reset
Power
Attn
Network/Status
Ararms
3231302928272625242322212019181716151413121110987654321
PRI Channel Status