Technical data

5
Remote Annex Quick Start for UNIX
166-024-857 Rev. A
2. Put the /user/annex/gui_am_R2.3 directory in your path on
the load host:
For C-shell:
setenv PATH ${PATH}:/usr/annex/gui_am_R2.3/bin
For Bourne and Korn shells:
setenv PATH=$PATH:/usr/annex/gui_am_R2.3/bin
export PATH
3. Set GUI_AM_DIR as follows:
setenv GUI_AM_DIR /usr/annex/gui_am_R2.3
Downloading the Images
Upon receiving a request from the Remote Annex, the erpcd daemon
running on the UNIX load host downloads the operational images to the
Remote Annex.
If you did not start erpcd when you installed the software, start the
daemon now by entering:
/usr/annex/erpcd
Hardware Setup
To set up the Remote Annex hardware:
1. Connect the power and connect the Remote Annex to the
network. If you are setting up a Remote Annex 6300 or
5393, connect DSU (DTE) to the Remote Annex and connect
CSU (net) to the PRI line.