Technical data

15
Remote Annex Quick Start for UNIX
166-024-857 Rev. A
5. Modify the telephone numbers for the Sync PPP and V120
blocks to reflect the numbers used to dial the Annex.
6. Copy and modify blocks for other telephone numbers.
7. Select the Annex and use the Call Defaults tab window to set
parameters not specified in the Session Parameter Blocks.
8. Choose Autodetect in the Mode box and enter the Annex
address as the Local address in the Dial-up Address box.
9. Choose Help > Contents or click on in the dialog boxes
for detailed information on using Quick2Config Annex.
Refer to Installing Remote Annex Network Software for
Windows NT for configuration examples.
Configuring Security
By default, the Annex allows unrestricted access. If you want to configure
Annex security, refer to the Remote Annex 6300 Supplement to the Remote
Annex Administrator’s Guide for UNIX for information on setting up
security files such as acp_passwd and acp_userinfo.
If you have requested dial-up addresses from the acp_dialup file, see the
Remote Annex 6300 Supplement to the Remote Annex Administrator’s
Guide for UNIX for information on adding users to that file.
Check the Security tab and other Quick2Config tab windows to make
sure the selections are appropriate to the configured security regime.
Help