Technical data
Table Of Contents
- Contents
- Installing Annex Software on the Windows Platform
- Installing Annex Software on the UNIX Host
- Hardware Setup
- Network Address
- Booting the Remote Annex
- Configuring the Remote Annex
- Configuring the Remote Annex 6300
- Initial Setup with na
- Setting PRI Channels Using Annex Manager
- Setting PRI Channels Using Quick2Config Annex
- 1. At the Window system, click on the Quick2Config...
- 2. Choose File > Add Annex, enter the name or IP a...
- 3. Click on the Annex name in the tree view.
- 4. Choose Config > Edit Configuration File to modi...
- 5. Modify the telephone numbers for the Sync PPP a...
- 6. Copy and modify blocks for other telephone numb...
- 7. Select the Annex and use the Call Defaults tab ...
- 8. Choose Autodetect in the Mode box and enter the...
- 9. Choose Help > Contents or click on in the dialo...
- Configuring Security
13
Remote Annex Quick Start for UNIX
166-024-857 Rev. A
2. Modify the following parameters in the external CSU
through its front panel:
FORMAT (FDL) = ANSI (or ATT)
CLOCK = SLAVE
DISTANCE = 133 ft.
3. Use na to enable SNMP sets, modify the PRI parameter
switch_type if it is other than 5ess (NI-2 or DMS100, for
example) and specify the distance between the Annex and
the CSU.
% na
command: annex 129.9.200.62
command: set annex allow_snmp_sets y
command: set pri switch_type dms
command: set pri dsx1_line_length 101-135
command: boot
command: quit
Setting PRI Channels Using Annex Manager
To configure Remote Annex Ports using Annex Manager:
1. Start Annex Manager:
gui_am
2. Enter the name of the Annex or its IP address and click on
.
3. Fill out the items in the window and click on
.
4. Repeat Step 3 for screen in the Setup Option Menu in the
upper right corner of the window.
Setup...
Apply