Technical data

166-024-857 Rev. A
Remote Annex Quick Start for UNIX
10
5. Choose Help > Contents or click on in the dialog box
for detailed information on using Quick2Config Annex.
See the on-line help or to Installing Remote Annex Network
Software for Windows for configuration examples.
Using the na Utility
You can also configure Remote Annex ports with the na utilities as shown
in the following examples involving non-RA 6300 Annexes installed
using default selections.
Modems
Annex supports inbound, outbound and inbound/outbound modems.
When entering port speed, set the highest speed supported by the modem.
Do not select autobaud.Set the port parameters using na:
% na
command: annex 192.9.200.62
command: port 6
command: set port speed 115200
command: set port control_lines modem_control
command: set port input_flow_control start/stop
command: set port output_flow_control start/stop
command: set port type dial_in
Inbound Modem
command: set port mode auto_detect
Outbound Modem
command: set port mode slave
Inbound/Outbound
command: set port mode auto_adapt
command: reset port 6
command: quit
Help